![]() To strike a great deal on personal care products from CVS ad, try the Extrabucks rewards. Should someone wish to have me calculate beam strengths for a specific application, PM me with the tank dimensions and I will be happy to run the numbers. It may not suit everyone's application but it should fit the bill for most common size tanks. There are other plans out there but this is a simple design using simple tools and common wood sizes. At the bottom, where there is no load, I used 2 x 4s to space the frames the correct distance apart. DIY Aquarium Stand Plans are also more affordable than ready-made options, as you wont have to pay for labor or material. The stands overall size is 60 long x 30 deep. These 16 plans allow you to craft a unique piece that caters to your specific needs and tastes. 21 pieces in 6 lenghts equals a tank stand that should fit the bill for most people. A DIY aquarium stand is a perfect solution if you prefer the latter. Doors can be mounted to the legs as desired. These 2X4s act to spread the weight of the tank over a larger area.Ĭovering the sides of the stand with plywood will help to stiffen the stand against twisting and shifting. The ones on the short sides of the stand provide a flat surface for attaching a plywood facing and while they do provide some strength, they are optional. These 2X4s support the weight of the tank. These 2X4s are shorter then the tank is tall. Theses will be made of the same material as the upper rails. These will be sized according to length: 2X4 for 48" or less for smaller tanks (Rule of thumb is 75g-90g) 2X6 up to 72" with 125g-150g being acceptable For longer spans and larger tanks 2X8s are recommended. *The blue piece between the upper rails (red) works to keep the upper rails from twisting.įirst off: The calculations below are based off of a stand that is "W" inches wide X "D" inches front-to-back X "H" inches high. These provide limited load strength but serve to make assembly easier and help keep the stand square. *The box frames are screwed together first, then the legs are built off the bottom frame, the top frame is then placed on top and secured to the legs. Like color pieces are the same length and of the same board size. *The plan for this stand consists of 21 pieces. The bottom frame transmits the load of the tank into the floor. The legs are made of several pieces of 2X4 to assist in construction and sheething the stand in plywood for strength and cosmetics. You should also use a piece of 3/4 plywood under the foam. The upper one supports the tank and transfers the load to the legs. A piece of rigid foam is a good addition to your stand build, and goes between the tank and stand. ![]() The basic principle of the design is two box frames connected by four legs. ![]() This design is a compilation of several designs into one place and includes the calculations needed to generate a cut list for any custom design. The reason for starting this thread is to provide a template for a relatively simple DIY stand design. A DIY aquarium stand will showcase the fish tank so it can become the focal point of the room and a great conversation piece.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |